Run your fingers over the scratch while the surface of the car is clean.
How to get light scratches off car.
How to remove small car scratches.
And when the clearcoat comes off your car s paint will be exposed to nature s elements uv rays snow rain wind.
But be careful light scratches only sit on the clearcoat.
Stop rubbing if you feel you ve done your best but the scratch isn t coming off.
Besides shoe polish nail polish and toothpaste you could also use candle wax to remove the light scratches on your car s paint.
Rub with firm hand pressure using back and forth strokes for about 60 seconds.
If you cannot feel the scratch it is a light scratch that will likely be fixed using the first method.
Remember that the more you rub the more clearcoat comes off.
Again make sure that the area is clean and rub the candle wax gently on the damaged surface.
Apply the turtle wax scratch repair renew to a soft cotton microfiber towel folded into a 6 x 6 square.
Start by washing and drying the car.
If you can feel the scratch and your fingernail does not catch easily on the scratch it is a deep clear coat scratch that must be fixed using the second method.
Fix scratches on car.
Don t worry spraying the fine scratches won.
After watching this video you will know how to.
Follow up with polishing compound to restore the shine.
If your fingernail does catch on the scratch it may.
After you ve removed the scratches it s time to get your car clean again.
It isn t a car scratch remover but it will work well to cover up super light scratches on your paint.
Small scratches are just big enough to stop your fingernail in our test.
Rubbing dirt and debris into the scratched area will make the scratches worse.
Squirt rubbing compound onto the polishing pad and spread it around with the pad.
You can take your car to a car wash or wash it yourself.
Wash and dry the scratched area.
Spread the product to a 2 x 2 foot square area on the finish.
Use a clay bar to remove any lingering particles from your bodywork then make sure the affected area is well waxed to.
Spray the area well so it s nice and wet and the water is able to blast out any small particles of dust and dirt that may be lodged in the tiny scratches so they don t get further embedded when you polish the surface.
Before you apply toothpaste to the scratches make sure that the area is very clean.
Then run the polisher or drill at 1 200 rpm until you get a light haze.
Take your hose and aim a concentrated jet directly onto the scratches.
Let dry to a light haze and remove excess with a soft cotton or microfiber.